Francisco Lopez de las Heras escribió:
hola!
> Alguien sabe como utilizar el modem como telefono manos libres, es
> decir, conectar un microfono y altavoz al modem y realizar marcacion,
> contestar a llamadas, etc..Tengo algo mas o menos hecho con VB y
> consigo marcar y abrir el puerto
>
Si tu módem soporta RockWell, esto es lo que necesitas. Yo he hecho
una app. en VB 5 de esto, si quieres te la paso.
SPEAKERPHONE MODE
8.1 OPERATION WITH
COMMUNICATION SOFTWARE
The full-duplex speakerphone operation can be used by
running a communication software application which
supports the Rockwell Speakerphone function. Follow the
instructions of the respective application package.
Alternatively, speakerphone operation can be used by
manually issuing AT command to the modem as
described in Section 9.2.
8.2 MANUAL OPERATION USING
TERMINAL MODE
8.2.1 Originating a Voice Call in
Speakerphone Mode
1. Invoke the terminal mode in your communications
package.
2. Enter AT and make sure that OK is returned. Enter
AT&F to reset modem configurations to default values. All
instructions to the modem are communicated through AT
commands. For example, ATD is the AT command for the
modem to dial; all AT commands start with the "AT"
characters. Refer to the RCV144ACF/SP Modem
Designer's Guide for the list and descriptions of the AT
commands that the RCV144ACF/SP target board
supports.
3. Enter AT#CLS=8#VRN=0#VLS=6 and press the
return key. The modem should respond with OK. This will
initialize the modem for speakerphone mode.
4. To dial, enter ATDTnnnnnnn where nnnnnnn is the
phone number of a remote party. The modem will report
VCON at the completion of dialing and indicate
speakerphone is on.
5. To hang up, issue ATH.
8.2.2 Answering a Voice Call in
Speakerphone Mode
1. the terminal mode in your communications package.
2. Enter AT and make sure that OK is returned. Enter
AT&F to reset modem configurations to default values. All
instructions to the modem are communicated through AT
commands. For example, ATD is the AT command for the
modem to dial; all AT commands start with the "AT"
characters. Refer to the RCV144ACF/SP Modem
Designer's Guide for the list and descriptions of the AT
commands that the RCV144ACF/SP target board
supports.
3. Enter AT#CLS=8#VRN=0#VLS=6S0=0 and press the
return key. The modem should respond with OK. This will
initialize the modem for speakerphone mode.
4. To answer a call in speakerphone mode upon receipt of
a RING message, enter ATA. The modem will report
VCON to indicate speakerphone is on.
5. To hang up, issue ATH.
Salu2kurro@leader.es